Description Plymouth Superbird Wing B-Body Produced only during the model year 1970, the Plymouth Superbird shares similarity with the Dodge Daytona produced a year earlier. Both of these cars were made for only one reason, NASCAR! The rear wing was mounted on tall vertical struts that put it into less disturbed air thus increasing the efficiency of the downdraft that it placed upon the car’s rear axle. For nearly 30 years the mathematic formula used to determine the exact height of the enormous wing was thought to be a highly guarded Chrysler secret. In the 1990s, a retired Chrysler project engineer claimed publicly that the height was determined in much simpler fashion: it was claimed that it was designed to provide clearance for the trunk lid to open freely. This is an urban myth. The actual height was set to clear the roofline so it was in clean air. Now you can get the same look with our fiberglass wing Super Bird Tail This item is molded from the original. It measures 64 inches wide and 24 inches in height. * High quality fiberglass Superbird Wing * Can be bought seperate from kit * Hand laid fiberglass for a stronger, more durable, quality product * We use the highest grade materials * All molds are adapted from the original part * Gray gel coat finish is perfect to sand, seal and paint * Minimal prep time * Direct Bolt On * Made in the U.S.A. Ships via truck freight. NOTE: Fiberglass panels require fitting, trimming, shimming, and special finishing. Unless you are experienced in working with fiberglass, we recommend using a qualified body shop. COMBINED CANCER/BIRTH DEFECT: WARNING: This product can expose you to chemicals including glass wool fibers (INHALEABLE & BIOPERSISTENT) which is known in the State of California to cause cancer and/or birth defects or other reproductive harm. For more information see www.p65warnings.ca.gov
